Distance Sensor#

By default, Distance Sensor points to the front of the vehicle. It can be pointed in any direction by modifying the settings

Configurable Parameters -

Parameter	Description
X Y Z	Position of the sensor relative to the vehicle (in NED, in meters) (Default (0,0,0)-Multirotor, (0,0,-1)-Car)
Yaw Pitch Roll	Orientation of the sensor relative to the vehicle (degrees) (Default (0,0,0))
MinDistance	Minimum distance measured by distance sensor (metres, only used to fill Mavlink message for PX4) (Default 0.2m)
MaxDistance	Maximum distance measured by distance sensor (metres) (Default 40.0m)
ExternalController	Whether data is to be sent to external controller such as ArduPilot or PX4 if being used (default true)

For example, to make the sensor point towards the ground (for altitude measurement similar to barometer), the orientation can be modified as follows -

"Distance": {
    "SensorType": 5,
    "Enabled" : true,
    "Yaw": 0, "Pitch": -90, "Roll": 0
}

Note: For Cars, the sensor is placed 1 meter above the vehicle center by default. This is required since otherwise the sensor gives strange data due it being inside the vehicle. This doesn't affect the sensor values say when measuring the distance between 2 cars. See PythonClient/car/distance_sensor_multi.py for an example usage.